AutoMovie API
    Preparing search index...
    • The trace's seed.

      Parameters

      • seed: IAutoMovieConstructionSeed

        The seed record, metres.

      • part: IAutoMovieSolidSurface

        The part face's surface.

      • layers: readonly number[]

        The part chain's layer stations, mm, increasing.

      • host: IAutoMovieSolidSurface

        The host face's surface.

      • face: number

        The host face's index in the host atlas.

      • tolerance: number

        Largest gap accepted at the meeting, mm.

      Returns string | { face?: number; phi: number; s: number; theta: number; y: number }

      The seed, or the premise the search broke.

      Point mode converts chart lengths without checking a meeting. Search mode is a finite local search over one station line, or phases lines round the part in a fixed order; its failure names nonconvergence or inadmissible meetings rather than certifying absence of every crossing.

      • string
      • { face?: number; phi: number; s: number; theta: number; y: number }
        • Optionalface?: number

          Zero-based host atlas face index, default 0; callers must supply a valid index.

        • phi: number

          Initial part v in its original periodic chart units; phase mode uses it as the starting radian parameter.

        • s: number

          Initial part u, usually station millimetres.

        • theta: number

          Initial host v on the selected face, in that face's chart units.

        • y: number

          Initial host u on the selected face, in that face's chart units.