AutoMovie API
    Preparing search index...

    Interface IAutoMovieConstructionCurvatureWidth

    A chord from a join's curve to one rail as a share of that surface's radius of curvature across the curve: share / |k|, k the normal curvature of the rail's surface in the direction square to the curve in its tangent plane at the traced point, capped at cap and, where end is given, at that share of the station distance from the traced point to the rail surface's nearer end.

    A rail placed farther round a surface than its radius of curvature in that direction turns past the surface's side and folds the blend, at any scale. A share below one keeps every rail inside that radius wherever the curve runs: a small part's own tight curvature (a lip's or a lid's long-axis end) narrows its rail there and lets it widen where the part is flat. The cap bounds the chord where the surface is flat across the curve (k near zero). The engine evaluates the law at every traced point and reads it between them by the periodic cubic B-spline through those values, C2 round the loop.

    A surface that ends near the curve (a dome closing on its pole, a short part) leaves its rail no room past that end however gentle its curvature: end bounds the chord by a share of the station distance to the nearer end, so the rail stays on the surface as it approaches a pole.

    Engine admission: share inside (0, 1); cap positive; end, when given, inside (0, 1).

    interface IAutoMovieConstructionCurvatureWidth {
        cap: number;
        end: number | null;
        share: number;
        type: "curvature";
    }
    Index
    cap: number

    The largest chord, metres, positive.

    end: number | null

    The chord's share of the station distance from the traced point to the rail surface's nearer end, inside (0, 1); null for no end bound.

    share: number

    The chord's share of the radius of curvature across the curve, inside (0, 1).

    type: "curvature"

    Discriminator.