AutoMovie API
    Preparing search index...

    The anchors of a section family.

    interface ILayout {
        anchors: IAutoMovieHumanConicSection.IAnchor[];
        least?: number | readonly number[];
        mirror: boolean;
    }
    Index

    Anchors in increasing phase; for a mirror layout the half from phase 0 to pi inclusive.

    least?: number | readonly number[]

    Least shoulder an arc of this family takes; absent, only the model's edge bound holds. An arc whose shoulder lies far under the ellipse's sqrt(2) - 1 hugs its chord and turns at its ends, and where two such arcs meet at an extreme the wall turns within a few millimetres: f1's trunk held 0.22 to 0.36 either side of its side extreme over the hips, turned 1.06 degrees a half millimetre there against 0.2 elsewhere, and drew an upright line down each hip. It is a family's own number, not the model's, because other walls (the face's, the leg's) were fitted with lower shoulders where their skin wants them.

    A list holds one least per arc, in the order of the shoulders (leastOf). The bound belongs to the arcs that need it, not to the whole section: f1's foot end was fitted under 0.3 for the two arcs at its top, whose corner drew a slot at the big toe's root, and the same bound held the sole's arc at 0.3 from 896 to 960 mm, where the skin wants a flatter arc, so the wall stood 1.0 to 1.7 mm under the sole and each section fitted alone without it came within 0.4 to 0.85 mm.

    mirror: boolean

    Reflect the listed half in the median line v = 0.